non-interactive install new protocol onto specified interface(s)- [preferably from batch]
Hi there,
I would like to know, if is possible to install new protocol to specific
network interface other way than:
-------------------------------------------------------------
- open the configuration panel for the network card in use
(either right click on the icon on the SYSTRAY, or go to
Control Panel -> Network and select one card)
- click on Properties->Install->Service->Add
- click on 'Driver Disk' and select 'protocol.inf' in this folder
- select 'this_protocol' which is the only service you should see
- click accept on the warnings for the installation of an unknown
driver (roughly twice per existing network card)
--------------------------------------------------------------
I play a bit with devcon.exe but this does not seems to be good way. Is
there any other?
Petr Laznovsky
June 8th, 2010 1:29pm