Hi, I was trying to enable the teredo client in Vista when joined to a domain. I gather from reading this is disabled by default when the computer is joined to a domain. I tried netsh interface ipv6 set teredo enterprise client and show teredo still displays: Type enterprise client server name teredo.ipv6.microsoft.com Client Refresh Interval 30 sec client port unspecified state offline error client is in managed network How do you turn this on? CCNA, A+, N+

Well i am not sure how exactly your network works in relation with the teredo client.... but i have pasted a link below which may help you...http://www.windowsnetworking.com/articles_tutorials/Windows-Vista-Resource-Kit-Chapter-23-Supporting-Users-Using-Remote-Assistance-Part3.htmlif it does not help please do post back...Regards, KOWSHAL H.M. a.k.a W@R10CK

Hi, Thank you for posting. Based on my research, I would like to suggest the following: 1. Please refer to the following document and run the command to see if it works: Teredo and the PNRP Global Cloud http://blogs.msdn.com/p2p/archive/2007/03/22/teredo-and-the-pnrp-global-cloud.aspx Please note the section: If it says Client is in a managed Network it means teredo has detected that you are in a corperate environment. If that is the case you need to set the Teredo type to Enterprise client Netsh int ter set state enterpriseclient. 2. Check your firewall with the following Knowledge Base: Firewall requirements for coexisting with Teredo http://support.microsoft.com/kb/968510 Hope this helps. Thanks.Nicholas Li - MSFT

Thanks for the help, I'll give those a tryCCNA, A+, N+