Hi all,

I have installed a UAG 2010 with SP3.

The public host name is "portal.mydomain.com" and the trunk name is "SECPortal"

I can surf to the external URL from the Internet and get the login page. After entering username and password I get the "Checking for device compliance..." then "Redirecting to login page" after that I get the "404 page not found" error and the following:

portal.mydomain.com:445/uniquesig9447c0d5a233fca0932f8f6da6153d181b6e7d8640462083a4f43dd402706ab7/uniquesig0/SecureSECPortalPortalHomePage/

I use NAT in the FW (since this is a lab env).

This might be a web configuration issue but I haven't really found some thing on the forums that could help with the problem.

Any nput is highly appreciated.

Regards, 

Hi,

this problem can be caused from the request limitation in IIS/UAG or on a system in front of the IIS/UAG..

http://www.iis.net/configreference/system.webserver/security/requestfiltering/requestlimits

In your URL I see calso that you access portal.mydomain.com on port 445? is this a typo? Verify first that it is working on the standard port 443.

Regards,

Lutz

Hi,

this problem can be caused from the request limitation in IIS/UAG or on a system in front of the IIS/UAG..

http://www.iis.net/configreference/system.webserver/security/requestfiltering/requestlimits

In your URL I see calso that you access portal.mydomain.com on port 445? is this a typo? Verify first that it is working on the standard port 443.

Regards,

Lutz

• Marked as answer by theislander 1 hour 53 minutes ago

Hi,

this problem can be caused from the request limitation in IIS/UAG or on a system in front of the IIS/UAG..

http://www.iis.net/configreference/system.webserver/security/requestfiltering/requestlimits

In your URL I see calso that you access portal.mydomain.com on port 445? is this a typo? Verify first that it is working on the standard port 443.

Regards,

Lutz

• Marked as answer by theislander Thursday, November 07, 2013 9:56 AM

Hi Lutz,

And thanks for your reply! Actually the :445 is the forward port in my FW since I am using a single public IP address for several things (lab env). 443 is already used by another site.

I checked and found out the following: when I manually add :445 to the above link "portal.mydomain.com:445/uniquesig9447c0d5a233fca0932f8f6da6153d181b6e7d8640462083a4f43dd402706ab7/uniquesig0/SecureSECPortalPortalHomePage/" i get to the home page of the portal. I am just not sure what to configure so that the URL does not bounce back to __https://mydomain.com/ (meaning that the browser drops the port number from the URL) could be a network config as I mentioned.

Hi,

might using AppWrap and SRA will do it for you. See Ben Ari's blog

http://blogs.technet.com/b/ben/archive/2011/05/12/appwrap-and-sra.aspx

But it looks to me as too much effort for a lab environment.

Regards,

Lutz