Hi

Not able to access the Networking settings tab on the TMG array, keeps popping up with a error 0xc004041c.

"This network adapter gateway is not defined using a valid IP address.

The error occured on object '' of class 'StaticRoute' in the scope of the array 'Zebra1'."

Can't see any correlation with the errror and plus it's not defining which interface is the problem on.

Any clues?

Please do an IPconfig /all on your array servers and post here. Also route print.

Please remove any domain names :-)

Hi,

Thank you for the post.

Please check if you have mapped the correct IP's to the publishing rule and do route print to check static routes. Meanwhile, you can run TMG BPA to check the configuration.

Regards,

Hi

I have same problem with access networking

I need remove wrongly added static routes unfortunately when i removed static routes via command line (route delete) after while TMG restore static route back from configuration storage

Article bellow describes this behavior. I can't remove routes via TMG console (route tab) because it is under networking which is unaccessible due to bad static routes configured and removing routes directly from configuration storage is not recommended.

Any advice?

Thanks Jan

   http://blogs.technet.com/b/isablog/archive/2010/02/10/routing-mania-or-why-removing-a-route-from-the-operating-system-doesn-t-change-the-routing-in-forefront-tmg.aspx

Hi,

I have same problem, please help

Thanks,

Denisa