Permissions Issue
Are there any knowledge base articles for installation instructions on
WIN2008 server and/or attaching Win7 workstation to Win2008 Server with termini setup for OSAS.
When I attached the workstation it kept using UNC pathing even if it
showed a mapped drive in the properties.
This caused an error 4.
The UAC seemed to be at least part of the problem, but if anyone has a
method that works I am all for it.
Any input appreciated
Thanks
Steve
Here is the other
Client has win2008 R2 server.
XP workstations run fine.
(on Vpro5 rev 9.00)
They added a Win7 workstation.
They got error 4. Vpro5 does not load.
Down UAC on the workstation and they get in.
However if they turn UAC back on back to error 4.
I'd like to be able to work with it on as most machines will come that
way. But can live with that.
However in the code we create temporary files
MKEYED ....
It runs once. However If the process erases and recreates the temp
file
We almost always get an error 18.
If I step through the program it works.
I add a wait 1 between erase and MKEYED statement and it works. (In
one of these places as a test)
User has full control of main directory and subs inherit rights.
Any input appreciated
December 11th, 2010 11:46am
Hi Steve,
Thanks for the post!
I’m quite confused about your questions. It’s better if you make it more clear.
For the first question, what’s the error message you got? How about turning off
the UAC on Windows 7?
Maybe a screenshot could help us troubleshoot the issue, you can upload the picture using
SkyDrive.
In addition, you can refer to this article to understanding more about Windows 7 and Windows Server 2008R2.
Integrating Windows 7 and Windows 2008 R2
Regards,
MiyaThis posting is provided "AS IS" with no warranties, and confers no rights. | Please remember to click "Mark as Answer" on the post that helps you, and to click "Unmark as Answer" if a marked post does not actually answer
your question. This can be beneficial to other community members reading the thread.
Free Windows Admin Tool Kit Click here and download it now
December 14th, 2010 2:09am
Miya
Sorry this was a re-post from another group where the context was more clear.
I am using a Vpro5 program from Basis International and the error codes are comming from there.
I did down the UAC on the workstation, and that lets me into the software.
However I then get error 18. Again from the Vpro5 sortware.
Oerating system code is -5.
Normally this would be a permissions questions, but if I step through the code. It works.
It seems more like a timing issue.
However I am open to any responses.
Thanks
Steve
December 15th, 2010 6:00pm