Hello,
how can i change the LANA Numbers on Windows 8? The Lanacfg.exe doesnt work.
Thanks
Technology Tips and News
Hello,
how can i change the LANA Numbers on Windows 8? The Lanacfg.exe doesnt work.
Thanks
Hi..!
Were you able to resolve this problem? I have the same problem using Aloha QS
I looked around for some information about this LanaMap registry key.
In the regisry at the NetBIOS Linkage settings, where the NetBIOS
LanaMap value must contain a two-byte value (a "tuple") for each
string in the NetBIOS Bind value. For details on how to view these
values, see the second method in the "Workaround" section of this
article.
The following is an example of a single string in the Bind value:
\Device\NetBT_CPqNF31
If this is the only string in the Bind value, then the LanaMap value
must contain only one two-byte tuple for the one Bind string.
The LanaMap must contain the correct number of two-byte tuples, for
example:
1 string in the "Bind" value = 1 two-byte tuple (for example, 01
01)
2 strings in the "Bind" value = 2 two-byte tuples (for example, 01
01 01 02)
in our enviroment:
------------------
Here you can see our Bind registry key snapshot, it says we have 4
Device string in it.
\Device\NwlnkNb
\Device\NetBT_Tcpip_{61096195-EC12-4FC5-BAA6-42A1D6E0C69E}
\Device\NetBT_Tcpip_{3E06ADA6-B8FF-4AC9-A5E1-2FF196CB0750}
\Device\NetBT_Tcpip_{C67832FC-A091-4137-BA55-86B200F10298}
This means the LanaMap key must hold 8 numbers or 4 tuples. And here
it is.
01-00 01-01 00-02 00-03
I think the first tuple in each set is 01 if its enabled, the second
tuple must be the Lana number of the corresponding transport device
that NetBIOS should bind to (as listed in the Bind value)
WARNING: Using Registry Editor incorrectly can cause serious problems
that may
require you to reinstall your operating system. Note that you should
back up the registry before you edit it. If you are running Windows NT
or Windows 2000, you should also update your Emergency Repair Disk
(ERD).
Best regards..!