Hi,

Apologies in advanced, I have very basic knowledge of FIM Sync!

I have GALSync nicely configured to sync contacts from Domain A to Domain B.  This works perfectly and has helped a lot with our cross forest move.

However I now need to add Domain C into the mix which only needs certain users from Domain A syncing across (these do not need to be in Domain B).

I have tried adding a connector filter on Domain C's Management Agent as "Mail does contains certaindomain.com" however it will still sync all the unwanted contacts from Domain A.

How can I go about this?  Will I need to wait for us to finish the migration to domain B and then add the OU's I need?

Any help would be appreciated as I would like to start adding contacts into Domain C

• Edited by traveyb1 12 hours 47 minutes ago

Are you using codeless or coded solution.  If you are using codeless, there are 2 filter, inbound and outbound.  Make sure the filter is applied to outbound section.  If you are using coded (classical), you need to add a statement in the code under provisioning section.  (Something like "IF NOT, THEN PROVISION")

Hi,
Thanks for the reply.
I haven't a clue to be honest.  I just created 2 Active Directory global address list (GAL) management agents, filled in the bits and that was it!