Hello , 

When i create a new OU in Active Directory, when i run a Delta Import i don't see any changes and i'am obliged to run a full import to see the new imported OU , is it normal !! 

Thanks

Hi

You should see the newly created OUs in a Delta Import run. In case you have limited (filtered) the OU structure for your imports on the "Configure Directory Partitions" tab -> "Containers" button you will not see new OUs during imports.

Henry

i explain my problem 

i have OU = Test and it's checked in MA AD and imported in MV. 

When i create a sub-OU and run a DI i don't see any changes. But when i open the MA configuration to verify if the Containers is checked and juste after that i run a delta import i see the creation of the OU.

When i run FI profile it's OK.

Any idea 

I found the problem, actually when i create an empty OU i should run a full import 

But when the new OU contains user the delta import is sufficient.

• Marked as answer by gentelman 22 hours 39 minutes ago

I found the problem, actually when i create an empty OU i should run a full import 

But when the new OU contains user the delta import is sufficient.

• Marked as answer by gentelman Thursday, February 13, 2014 1:09 PM
• Unmarked as answer by gentelman 21 hours 30 minutes ago

I found the problem, actually when i create an empty OU i should run a full import 

But when the new OU contains user the delta import is sufficient.

• Marked as answer by gentelman Thursday, February 13, 2014 1:09 PM
• Unmarked as answer by gentelman Friday, February 14, 2014 2:18 PM

I have the same problem when deleting OU i have to run a Full Import to see the deletion in FIM Synchronisation Engine !! 

Any idea !!