Cannot passthrough physical disks from IBM M1015 SAS Controller to Hyper V

Hello! I am currently running Hyper-V with Windows 8.1 Pro Hypervisor and VM. I recently installed an IBM M1015 SAS controller flashed to IT mode but when I try to add the physical disks to Hyper-V I get the error 'VM was reset because an unrecoverable error occurred on a virtual processor that caused a triple fault. If the problem persists, contact Product Support. (Virtual machine ID)'

This problem occurs with a single or multiple drives. All drives connected via local controller passthrough fine through Hyper-V. The VM is running just bare windows and the Hypervisor also has minimal software running.

The relevant hardware is as follows:

* Asrock H77 Pro4-M motherboard w/ 32gb ram

* 6x WD Black 2tb

* IBM M1015 SAS Controller flashed to IT Mode

Thanks

August 30th, 2015 3:46pm

This topic is archived. No further replies will be accepted.

Other recent topics Other recent topics