Hello all, I have recently configured a RAID array. I have an Intel DP45SG motherboard, along with five hard drives. Three are 250GB and two are 1TB. I was going to put two 250GB hard drives in RAID 0, so I performed a backup using Acronis True Image Home 2011. I booted to the recovery media, placed the image from my single hard drive onto my new RAID array, and proceeded to boot. I saw the Windows start screen. It briefly showed the Windows 7 startup screen, and suddenly I presented with the blue-screen-of-death. I rebooted my computer, and attempted to launch startup repair, and it gave me this message: "The boot selection failed because a required device is inaccessible." If anyone can assist me with this issue, it would be greatly appreciated. Thank you Computer

You need the following driver for RAID. RAID: Intel® Rapid Storage Technology Driver for Intel Desktop Boards Important Note: Microsoft provides third-party contact information to help you find technical support. This contact information may change without notice. Microsoft does not guarantee the accuracy of this third-party contact information.Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.