Hi i created a pppoe connection and successfully connected to my isp through this connection. And i tried to connect using this connection from windows 2k8 r2 that it's a domain member , using the rasdial.exe command but was unsuccessful (error is 691) Any help? RegardsMCITP Enterprise Messaging Administrator, MCITP Enterprise Administrator, MCSE, MCDBA

Hello, Based on my research, to resolve this issue, use each of the following methods. After you use one method, test to confirm if the issue continues to occur. 1. Create a New Telephon.ini File To create a new Telephon.ini file, follow these steps: Rename the Telephon.ini file located in the \Windows folder to Telephon.old. Restart the computer. Double-click the Tapiini.exe file located in the \Windows\System folder. Note that the program runs very quickly. The Tapiini.exe file creates a new Telephon.ini file in the \Windows folder. 2. Connect to CompuServe To connect to CompuServe by using the CompuServe software included in Windows 98, follow these steps: Click Start, point to Programs, point to Online Services, point to CompuServe, and then click CompuServe 4.0. Click Setup. Type your member name, member ID, and password, and then click OK. Click Internet. Click Yes when you are prompted to use Dial-Up Networking to connect to the Internet. Click the appropriate country, and then click OK. After you connect to CompuServe, log off CompuServe, and then restart your computer. 3. Verify the Version of Rasapi32.dll To verify that the current version of Rasapi32.dll is the file included in Windows, check that the value data in the Path value of the following registry key is Rasapi32.dll: HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\RemoteAccess\Authentication\SMMFiles\PPP For additional information about how to modify the Windows registry, click the article number below to view the article in the Microsoft Knowledge Base: 136393 (http://support.microsoft.com/kb/136393/EN-US/ ) How to Modify the Windows Registry You may be able to reinstall Dial-Up Networking to change the registry key. For additional information about how to reinstall Dial-Up Networking, click the article number below to view the article in the Microsoft Knowledge Base: 181599 (http://support.microsoft.com/kb/181599/EN-US/ ) How to Remove and Reinstall Dial-Up Networking and TCP/IP Files NOTE: If you use CompuServe as your primary ISP and you change this value data in the registry, you may not be able to log on correctly. For more information, please view the Tech article below: Filter the scope of Group Policy according to security group membership http://technet.microsoft.com/en-us/library/cc786636(WS.10).aspx Hope all the information will be helpful. Best regards, Tom ZhangTom Zhang MSFT