All,

Is there a way to debatch an incoming EDI file, in my case a customized 824, similar to creating a batched outgoing file using Biztalk R2? If there is'nt, what is the best possible route?

In the generated EDI message below, I would like to split the ST sections into 3 messages, or generate a master XML with the ST 3 nodes ...

Appreciate your feedback ...

ISA*00*00000ISA02*00*11111ISA04*01*2222222222ISA06*01*3333333333ISA08*670123*0123*U*00200*111111891*0*I*:~
GS*AA*GS02*GS03*45670123*01234567*892*X*00401~
ST*824*ST02~
BGN*00*BGN02*01230123~
OTI*BA*01*OTI03~
REF*01~
AMT*01*457~
NM1*001*1~
SE*7*ST02~
ST*824*ST02~
BGN*00*BGN02*01230123~
OTI*BA*01*OTI03~
REF*01~
AMT*01*457~
NM1*001*1~
SE*7*ST02~
ST*824*ST02~
BGN*00*BGN02*01230123~
OTI*BA*01*OTI03~
REF*01~
AMT*01*457~
NM1*001*1~
SE*7*ST02~
GE*3*892~
IEA*1*111111891~

Thanks,

Kartik

Use the option 'Split Interchange as Transaction Sets' inEDI party settings(present under party as interchange sender -> Ack generation and validation)

Koushik

HI Kartik,

I have the same question, did you get this resolved if yes can you please pass me the solution  at vsoneta@yahoo.com

Thanks

Soneta

Can anyone help me with the same scenario, where I have to debatch the incoming 850 to biztalk and send the single edi's to vendor(with each ST).

I was looking for Split Interchange as Transaction Sets, but I cannot find it