Windows servere 2008 stuck in recovery mode after power failure but Windows boot work
I have a windows servere 2008 R2 Embedded servere running at a site with no technical people. So I want It to recover automatically.
After a powerfailure during a boot up the system comes up with with the screen "Windows Error Recovery", and gives two options
1) "Launch Startup Repair (recommended)"
2) Start Windows Normally
It counts down from 30 seconds and "Launch Startup Repair" - This always fails
But if I manually choose the option "Start Windows Normally" it always comes up and works fine.
My question is - how do I change this so It always try "Start Windows Normally" by default instead off the "Launch Startup Repair".
Again - I need this because I havent got any technical persons at the server site
September 14th, 2012 6:02pm
Hello,
Type the following at the command prompt:
bcdedit /set {default} recoveryenabled No
Miguel Fra | Falcon IT Services, Miami, FL
www.falconitservices.com |
www.falconits.com |
Blog
Free Windows Admin Tool Kit Click here and download it now
September 14th, 2012 8:35pm