Hello, Currently I'm struggeling with snmp, particulary working with a MIB. I use the winapi for communication with the device. From that device I have the MIB file. I did already a lot of searching, but I cant find an solution for importing a MIB. I found a lot about agents, but they use dll's instead of MIB's. Do I need to convert this MIB into a dll? From web "Users can add other extension agent DLLs that implement additional MIBs.To do this, they must add a registry entry for the new DLL under the SNMP service.They must also register the new MIB with the SNMP management console application.For more information, see the documentation included with your management console application." So can someone help me with this issue? Thx in advance!!

Hi Customer, Please read the below PDF, it could load MIB to SNMP agent. 4.4 Loading / Unloading MIB Modules http://www.mg-soft.com/files/SNMP_Agent_Simulator.pdf MG-SOFT SNMP Agent Simulator 2010 http://www.mg-soft.com/download.html#SIMULATORWIN Important Note: This response contains a reference to a third party World Wide Web site. Microsoft is providing this information as a convenience to you. Microsoft does not control these sites and has not tested any software or information found on these sites; therefore, Microsoft cannot make any representations regarding the quality, safety, or suitability of any software or information found there. There are inherent dangers in the use of any software found on the Internet, and Microsoft cautions you to make sure that you completely understand the risk before retrieving any software from the Internet. Regards, Rick Tan