I am using a windows server 2003. The server was last used on Friday 24th September and was working and responding fine. Since yesterday I can get the server to power on but it will not display anything on the monitor and i get a message on the moinitor saying "No input Signal". I have opened up the case to have a look and everything seems to be connected and the fans are spinning correctly but cannot get the server to communicate with the monitor. I have tried the monitor with another PC and it works so i know that the monitor is working. Please advise. Thanks Ketan

bad video card? if it's not integrated into the motherboard try swapping it, or at least reseat it. bad cable (computer to display)? was this part of your monitor test? do you hear any beeps whe the server starts?

I am using a windows server 2003. The server was last used on Friday 24th September and was working and responding fine. Since yesterday I can get the server to power on but it will not display anything on the monitor and i get a message on the moinitor saying "No input Signal". I have opened up the case to have a look and everything seems to be connected and the fans are spinning correctly but cannot get the server to communicate with the monitor. I have tried the monitor with another PC and it works so i know that the monitor is working. Please advise. Thanks Ketan Did you try a known-good monitor on the server? If not the monitor... it's your video card or motherboard. Steve Kline Microsoft Certified IT Professional: Server Administrator Microsoft Certified Product Specialist Microsoft Certified Network Product Specialist This posting is "as is" without warranties and confers no rights.

Hi, As Roy and Steve said, this should be a hardware issue. Since the monitor is good, you will need to check the video card, cable and motherboard problem. Based on the current situation, you had better contact the hardware vendor to diagnose and replace the damaged hardware device for you. It is inconvenience for us to diagnose the hardware issue in forum. Regards,Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

Hi Thank you for your reply. No there are no beeps when i start the server. Thnaks

Hi, I would like to confirm that have you checked the hardware problem and what is the current situation? Regards,Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.