Is there any way to auto resolve the alert , the alert is generated due to connectivity issue for minimal amount of time ..

Please advise...

We have options to auto resolve the alerts that are generated from Monitors. Check you monitor properties in "Alerting" tab. Alerts can be set to auto resolve when the monitor state turns healthy again.

Alerts from Rules cannot be auto resolved.

alert can be generated by monitor or rule. Alert generated by rule cannot be autoresolve and need manually to close the alert. for monitor alert, whether it is auto-close or not is due to the monitor setting. Usually, monitor alert can be closed when monitor health state tun back into healthy state.

Roger

alert can be generated by monitor or rule. Alert generated by rule cannot be autoresolve and need manually to close the alert. for monitor alert, whether it is auto-close or not is due to the monitor setting. Usually, monitor alert can be closed when monitor health state tun back into healthy state.

Roger

• Proposed as answer by Elton_JiMicrosoft contingent staff, Moderator 22 hours 57 minutes ago

alert can be generated by monitor or rule. Alert generated by rule cannot be autoresolve and need manually to close the alert. for monitor alert, whether it is auto-close or not is due to the monitor setting. Usually, monitor alert can be closed when monitor health state tun back into healthy state.

Roger

• Proposed as answer by Elton_JiMicrosoft contingent staff, Moderator Monday, August 31, 2015 8:15 AM

alert can be generated by monitor or rule. Alert generated by rule cannot be autoresolve and need manually to close the alert. for monitor alert, whether it is auto-close or not is due to the monitor setting. Usually, monitor alert can be closed when monitor health state tun back into healthy state.

Roger

• Proposed as answer by Elton_JiMicrosoft contingent staff, Moderator Monday, August 31, 2015 8:15 AM

Thanks for reply i have check the setting of monitor , although auto resolve is already mark but still alert is not auto resolve when state is healthy...

Hi Sir,

It should work , please refer to following article

http://www.bictt.com/blogs/bictt.php/2011/03/17/scom-monitoring-a-service-part2

https://technet.microsoft.com/en-us/library/Hh212689.aspx

Also , please try flush agent cache to check the result  :

BBest Regards,

El

What is your auto-resolve setting? pls. screen dump auto-resolve setting and alert which does not auto-resolve such that i can easy to troubleshoot.

Roger