SMTP Error 5.7.1 Client was not Authenticated
I dont know if I posted this in the correct area - my apologies in advance. I have a 2 servers one runs Server 2008 Standard and the other 2008 R2. when i send SMTP mail on the Server 2008 using Telnet and then elho all work fine I get authenticated no troubles. however, when I do the same on my 2008 R2 server I get the message :smtp;530 5.7.1 Client was not authenticated" My Exhange server is 2007 SP2 Is this due to a change in 2008 R2 by design? If so, is there a work around????
February 17th, 2011 3:56pm

You mean to say You are telentting from Widnwos 2008 standard and telnet works fine to exchange server next when you telnet from another windows 2008 R2 server you get an error to the same exchange server. if it is .. then verify the connector to which you are connecting is the same and you do not have any specific settings for windows server on the connector,
Free Windows Admin Tool Kit Click here and download it now
February 17th, 2011 4:03pm

the receive connector is the same and I have the IP address of both servers listed under the Network Tab to receive mail from remote servers.
February 17th, 2011 4:20pm

Hi, On the receive connector, did you allow anonymous to the permissions? If not you will get the issue as you describe. /MartinExchange is a passion not just a collaboration software.
Free Windows Admin Tool Kit Click here and download it now
February 17th, 2011 4:46pm

Hi dvua, Please check the configuration on the Exchange Server by this way: Exchange Management Console->Server Configuration->Hub Transport ->Right click “Default receive connector” under Receive Connectors->Properties->Permission Groups->If you have not choose “Anonymous users”, please check box “Anonymous users”->Apply->Ok Thanks, Evan Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.
February 21st, 2011 4:50am

Hi, I have the same issue but i'm using /hosting mode so don't have access to the management console. Can I make the changes described above using the powershell? Thanks
Free Windows Admin Tool Kit Click here and download it now
July 4th, 2011 4:58pm

This topic is archived. No further replies will be accepted.

Other recent topics Other recent topics