I have a small test environment running Win2k8 with Exchange 2007 and IIS7. I'm trying to get VPN up and running with SSTP. I was able to find some step by step instructions in a few places online but they all assumed that the server I was using was connected directly to the internet with two network interfaces and I did routing and ran DHCP to give users on the LAN access to internet. My environment differs slightly from that config. I have a pair of Win2k8 Servers both running Exchange 2007. Both are domain controllers. Server A is the production Exchange server and Server B is a backup which I use as a target server for Standby Continuous Replication. This is the server where I'd like to setup VPN I have a Linksys RV082 Firewall/Router which connects the office to the internet on 99.166.xx.xx. DHCP for the network is run on the router which hands out 192.168.1.x addresses to all domain users. Server B is on the local network at ip address 192.168.1.x and I use NAT on the firewall to map the ip address to a different static ip address than the one which the router uses.... 99.166.xx.xx. I'd like to setup SSTP VPN on server with it's own pool of ip addresses that it uses (10.0.0.x) I could really use some step by step instructions on how to get this up and running. Thanks Rob

Hi, Since thisissue isabout network setup with Windows 2008 server,this is theforum for Exchange, I recommend you touse Windows 2008 Server forum to get better help. Microsoft TechNet>Forums Home>Windows Server http://forums.technet.microsoft.com/en-US/tag/windowsserver/forums/ More information share with you: Step-by-Step Guide: Deploying SSTP Remote Accesshttp://go.microsoft.com/fwlink/?LinkID=104247 Deploying SSTP Remote Accesshttp://go.microsoft.com/fwlink/?LinkID=102605 Hope it helps. Xiu