Migrated Exchange 2007 to Exchange 2013, Here is Envoirnemnt

1- Domain Controller with public and Local IP address

2- Exchange 2013 With Public and Local IP Address

Created host record in DNS name "ab-exchange" and Mapped to Both Local an Public IP of the Exchange Server ( Exchange is also a Domain Controller) named "exchange1"

OWA Working Fine, Configured Everything after Studying too many Tutorials.

When I Configure the MS Outlook, in Exchange Server Name i use the "ab-Exchange" when i click Check now it changes to Exchange Server name i.e "ab-exchange" as all the 400 outlook users use "ab-Exchange" so It don't Connect to Exchange.

What to do so that Users Connect without Changing the Name of Exchange Server name.

I Check Outlook anywhere its Configured with Virtual DNS name.

Attached is the Picture

Did you configure Autodiscoverserviceinternaluri in the cas server configuration?

Check my blog, it might help.

http://msexchangeguru.com/2013/05/10/exchange2013-migr

Did you configure Autodiscoverserviceinternaluri in the cas server configuration?

Check my blog, it might help.

http://msexchangeguru.com/2013/05/10/exchange2013-migration/

i tried but no help.

What Entries should i make in DNS for Public and Private IP Addresses?

Forum was not working for me on Sunday so I could not reply.

Did you check my blog?

You need to configure SCP.

You need to have autodiscover dns record in private and public dns which should be like  autodiscover.emaildomain.com

Once you have dns configure SCP on CAS servers then test at exr

Hi,

Outlook clients use the Autodiscover service to get the needed information.

On your server side, please run the following command to check your autodiscover service  :
Get-ClientAccessServer | FL Identity,AutodiscoverServiceInternalUri

On DNS zone, you need to create A records for public and private IP addresses.

Regards,

David