Hi,

I am creating network diagrams in Visio 2013 and would like to label both ends of the connector.  There's only one label by default and I want to know how to add more. Also if possible, use labels that stick on when the position of the connector is adjusted. I have been researching but some of the information that I get don't point to the right solution or is too complicated for me to understand. I appreciate if someone could post the step-by-step procedure on how to do this.

Thank you!

• Edited by ca06 Tuesday, August 18, 2015 4:33 PM

Check out Chris Roth's site (www.visguy.com), there are a couple of conversation strings that deal with this request.

al edlund

Hi ca06,

Please see this discussion, it would be helpful.

http://visguy.com/vgforum/index.php?topic=4689.0

Please Note: Since the web site is not hosted by Microsoft, the link may change without notice. Microsoft does not guarantee the accuracy of this information.

Regards,

George Zhao
TechNet Community Support