initial configuration question
I am new to ILM2. I have just installed the sync service and the server/portal. I created a new MA to connect to AD, created run profiles, and successfully ran them. I can see the user objects in the metaverse. However, in the portal i can only see my user object and the "built-in synchronization account". Is there something I must enable to be able to see the users and groups from my AD in the portal? I'm an trying to test dynamic group membership, but i can't test because I can't see any user objects.
October 6th, 2009 9:59pm

I recommend you to start here: FIM 2010 RC1 Getting Started if RC1 is the version you running (I do hope so)!? Especially Introduction to Inbound Synchronization and Introduction to Outbound Synchronization will be handy where you are right now... //HenrikHenrik Nilsson Blog: http://www.idmcrisis.com Company: Cortego (http://www.cortego.se)
Free Windows Admin Tool Kit Click here and download it now
October 6th, 2009 10:37pm

I am using RC0. Do you think it would be a good idea to uninstall and reinstall with RC1?
October 6th, 2009 10:48pm

Definitely, RC0 has a lot of problems (and likely RC1 too but not as many) and it will probably save you a lot of time going for RC1 at once but be sure to read the Release Notes and the Installation Guide before you go ahead and install... Henrik Nilsson Blog: http://www.idmcrisis.com Company: Cortego (http://www.cortego.se)
Free Windows Admin Tool Kit Click here and download it now
October 6th, 2009 11:00pm

Thanks for your help.
October 6th, 2009 11:10pm

This topic is archived. No further replies will be accepted.

Other recent topics Other recent topics