No im not using native mode!!! sorry

Hello, Im deploying client installation of sccm 2007 by GPO. I have two VLANs in one of each all is perfect, but the other one has a linux firewall... which ports do i have to open to a client installation succesfully??

Hello -Are you using Native mode ? If no this query should be the posted on General or Setup su forums? BTW, please find the port requirements in the below article.. http://technet.microsoft.com/en-us/library/ff189805.aspx (Ports Used During Configuration Manager Client Deployment) Ports that are Used with Group Policy-Based Installation Description UDP TCP Secure Hypertext Transfer Protocol (HTTP) from the client computer to a native mode management point. -- 80 (See note 1, Alternate Port Available) Secure Hypertext Transfer Protocol (HTTPS) from the client computer to a native mode management point. -- 443 (See note 1, Alternate Port Available) Server Message Block (SMB) between the source server and the client computer when you specify the CCMSetup command-line property /source:<Path>. http://technet.microsoft.com/en-us/library/bb632618.aspx (Ports Used by Configuration Manager in general)Anoop C Nair - This posting is provided "AS IS" with no warranties or guarantees, and confers no rights. |Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

Is port 80 a problem on the VLAN?Kent Agerlund | My blogs: http://blog.coretech.dk/author/kea/ and http://scug.dk/ | Twitter @Agerlund | Linkedin: /kentagerlund

When im in a client that is in the vlan that i have the problem i telnet the sccm server port 80 and it connect succesfull!! with 443 and 445 too

what exatly is the problem? Do you get the client installed? If yes, is it assigned to the site? Check the clientlocation.log and locationservices.log Kent Agerlund | My blogs: http://blog.coretech.dk/author/kea/ and http://scug.dk/ | Twitter @Agerlund | Linkedin: /kentagerlund

Basically there are tiny differences if you are using Mixed Mode rather than Native Mode. Client Communication in Mixed Mode and Native Mode http://technet.microsoft.com/en-us/library/bb680900.aspx Therefore you just need to open the ports that are mentioned in the article in An00p’s first reply.Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.

no client computer doesnt download the sccm client from the server!!!

The problem could be that ir has the proxy enabled? because they need it to have internet

Double check if the GPO was applied successfully at all (event log). See if there's ccmsetup.log in %windir%\system32\ccmsetup. The setup bootstrapper (ccmsetup.exe) has to download files from the management point.Torsten Meringer | http://www.mssccmfaq.de

The gpo apply ok!! In system32 or sysWOW64 doesnt download anything!!!!!!!

ccmsetup.log?Torsten Meringer | http://www.mssccmfaq.de