Hello.

I've just installed Windows 10, connected to Internet and set up a VPN connection for work. Now, all the traffic goes through the VPN connection. I need to route IP 192.168.0.2 traffic through VPN only and the other traffic through regular Internet connection.

I found a solution:

1. Right click the connection, and choose Properties.
2. Click "Networking" Tab
3. With TCP/IP selected, hit "Properties"
4. Click "Advanced"
5. Untick "Use default gateway on Remote network"

But when I hit "Properties" - nothing happens. (It is active, something has to happen, but no luck)

When I used Windows 7 I could hit the button succefully.

Thank you.

Sincerely,
Dmitry

• Edited by Dmitry Tregubov Saturday, August 01, 2015 6:56 AM

https://social.technet.microsoft.com/Forums/en-US/7c07b051-9520-405f-9aca-d187dfd3b34b/configure-networkadapter-l2tp?forum=WinPreview2014General

• Marked as answer by Dmitry Tregubov Sunday, August 02, 2015 8:43 AM

I also have this issue.  It has been around in different forms in insider builds.  How is this not fixed in the GA product yet?

A lot of the workarounds are for enabling or disabling default route... For me, I need to set the domain suffix for the connection, and that value doesn't seem to show up in the pbk file that others are mentioning.

Is there any fix that actually gets the IPv4 properties page to open up for a VPN connection?

rasphone.pbk has IpDnsSuffix=<<YourDNSSuffixHere>>

The problem I have is Win10 seems to ignore it.