I am trying to deploy Win 7 captured image in SCCM 2012.

I am getting the following error:

Failed to run the last action: Apply Data Image 1. Execution of task sequence failed. Unspecified error (Error: 80004005; Source: Windows)

I think this error is related to:

The requested target could not be resolved to a valid volume on this computer. Check your task sequence to ensure this drive is correct and that it is being created The parameter is incorrect. (Error: 80070057; Source: Windows)

I am using vm to deploy. 

I have Destination in the task sequence set to Next available formatted partition.

IS it possible that there is no partition? 

Where did i make a mistake? 

Thanks for the help.

Update:

Apply Data Image 1 set to Continue on error

Completed the build. But did not join the domain. so i think network setting did not run.

Hi,

I would enable F8 command prompt in the boot image and during the Task Sequence make sure that the disk is accesebale and that it is the right partition, It could be that you are trying to deploy the image to the BDEdrive useb by bitlocker but then the error message would be Another one.

Regards,
Jrgen

Thanks for the reply. I have F8 enabled. Thats how i got the smsts.log.

Again when i set "Continue on error" Apply Data Image 1 the build finished.

But not joining the domain?

I also do not see sccm client installed in control panel. But i do have c:\windows\ccm folder with everything in it?

Is there a way for me to upload a log file here?

Check the smsts.log file for additional information.

You can look here for more info...

http://www.networksteve.com/enterprise/topic.php/SCCM_OSD_-_Failed_to_Run_Task_Sequence_(0x80004005)/?TopicId=64994&Posts=12

http://support.microsoft.com/kb/2476568?wa=wsignin1.0