I have applied the patch to WSS 3.0 SP2 to two separate farms, a DEV and TEST environment. After the patch is applied, reboot is done, SharePoint Technology and Config Wizard is run I run a eYE Retina Scan against it. The TEST farm passed and Retina sees it as patched. The DEV farm however does not, Retina still sees it as missing that patch. Can you assist me in figuring out how I can confirm the patch is applied? I know there is a KB article on the file versions but many of those are in a CAB file that doesn't seem to have an affect on the Retina Scans. Any assistance or suggestions are appreciated. chris(dot)rapp(dot)ctr(at)autec(dot)navy(dot)mil

did you check under add or remove programs? and make sure you have show updates checked regardsAmar

First check under add or remove programs--> check the show updates box, on the DEV farm and make sure you have this KB2345304 security update +] not sure about the scanning tools you are using, however you can try using the Microsoft Baseline Security Analyzer 2.1.1 (for IT Professionals) which should identify the missing security updates +] Download Link : http://www.microsoft.com/downloads/en/details.aspx?FamilyID=B1E76BBE-71DF-41E8-8B52-C871D012BA78 Also article http://support.microsoft.com/kb/2345304 has the file attributes (or later file attributes) listed in a table which you can match with the ones in your environment . Hope this helps... Thanks, Manas Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread."

First check under add or remove programs--> check the show updates box, on the DEV farm and make sure you have this KB2345304 security update +] not sure about the scanning tools you are using, however you can try using the Microsoft Baseline Security Analyzer 2.1.1 (for IT Professionals) which should identify the missing security updates +] Download Link : http://www.microsoft.com/downloads/en/details.aspx?FamilyID=B1E76BBE-71DF-41E8-8B52-C871D012BA78 Also article http://support.microsoft.com/kb/2345304 has the file attributes (or later file attributes) listed in a table which you can match with the ones in your environment . Hope this helps... Thanks, Manas Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread."