Greeting,

I have an APPLICATION. v1, Sequenced without any issue.

now it become V1.1, and I load the V1 it in Sequencer, and base on that I use the updater to update it to V1.1 for whatever reason the sequencer stack ( couple of times, same thing).

I also start a new sequencing, install v1.0 and make sure it works, then continue update it to v1.1 then the same result

How can process this update?

Thanks

userausera

newbie in App-v

Does it update without using the sequencer on the same machine?

Did you tried on other machine?

It's very difficult to understand your post...

Is this a brand new version from the Vendor? If it is you're likely better off to create it new rather than upgrading your original package and installing the new version over it.

I would suggest using the Upgrade option if you need to change some reg settings, files etc.

Does it update without using the sequencer on the same machine?

Yes

It's very difficult to understand your post...

    sorry for that

Is this a brand new version from the Vendor? If it is you're likely better off to create it new rather than upgrading your original package and installing the new version over it.

    yes, it is new one. upgrade was stack in sequencer

• Edited by userausera 12 hours 30 minutes ago

Sequence the new version of the application as a New application in the Sequencer. That will give the best result

thanks, but this is an update, without the old v1 how to make it works?

error message attached as below,

Sequence as a New application. Install old version, Install Update. End Capture.

As Rorymon said, it's better to create a new package to avoid issues. Start Sequencer monitoring- Install v1.0-Install v1.1- stop monitoring.