SCOM Agent "Installation Still In Progress"
I have a simple setup of SCOM 2007 on W2K8 with one RMS and two agents. So three servers total, one is a DC (also 2K8) and the other a SQL Server (2K3 w/SQL 2K5), the remainder being the SCOM server itself. All on same domain, subnet etc.I am trying to deploy the agent through the Console and everything goes fine and I get a success in the deploy wizard except then there are still NO computers in the "Agent Managed" view. Both are in "Pending Management". Right clicking on them produces "Copy" and "Reject". Both "Approve" and "Install Agent" are grayed out. I have scoured the forums, internet etc.. for a resolution and most things point to firewall issues. I have disabled firewall on both servers (SCOM and Agent) with no change in success. What am I missing? I have gone on both agent servers and the agent was installed successfully, the services are started but the following events are occuring on the agent:Event ID: 20070The OpsMgr Connector connected to scom.int.netuitive.com, but the connection was closed immediately after authentication occured. The most likely cause of this error is that the agent is not authorized to communicate with the server, or the server has not received configuration. Check the event log on the server for the presence of 20000 events, indicating that agents which are not approved are attempting to connect.And on the server (to no suprise) are: Event ID: 20002A device at IP x.x.x.x:58641 attempted to connect but could not be authenticated, and was rejected.How can I resolve this issue?
March 11th, 2009 8:15pm
Hi,This is the Config Mgr. forum I think you posted this in the wrong forum.Kent Agerlund
March 11th, 2009 8:46pm
Thanks. I reposted in System Center Essentials - Monitoring. (Hope that is the right one).http://social.technet.microsoft.com/Forums/en-US/systemcentermonitoring/thread/c81ea10e-0462-4138-a41c-6b74d8091347
March 11th, 2009 8:58pm
Hi Bspindler, I am facing the same issue. Do u got a solution to above problem. Please help to resolve this. Regards, Sandeepk
July 8th, 2011 2:07am