Hi, I am trying to upgrade my sccm 2007 r2 secondary site to r3 .I have installed the hotfix 977384 and then installed r3 setup after it is installed it is not showing r3 installed in sccm console site properties rather showing r2 not installed.On primary site r3 is showing installed successfull.

Hi, The secondary site will replicate the R3 information, but it takes time. I have seen it take several hours. My advice, don't do anything, no reinstall, just wait :-)Kent Agerlund | My blogs: http://blog.coretech.dk/author/kea/ and http://scug.dk/ | Twitter @Agerlund | Linkedin: /kentagerlund

Hi, I have waited for replication more than 3 days it didn't updated. Then i have finally reinstalled it but still not showing r3.

Try logging on to the secondary site and running the R3 Setup Manually.David Baur

R3 must be installed manually on the secondary site. Did you manually installed R3 on secondary sites?Regards, Madan

Hi, As this thread has been quiet for a while, we assume that the issue has been resolved. At this time, we will mark it as "Answered" as the previous steps should be helpful for many similar scenarios. In addition, we’d love to hear your feedback about the solution. By sharing your experience you can help other community members facing similar problems. Thanks,Yog Li -- Please remember to click Mark as Answer on the post that helps you, and to click Unmark as Answer if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.