I have setup SCCM on win28K server but when I run the pre-requisit checker, it give me the following result. This software update addresses a browse dialog box error that might occur when the Configuration Manager console is installed on computers with 64-bit microprocessors. This update should be applied only to computers experiencing this particular issue. More information about this update is available at: http://go.microsoft.com/fwlink/?LinkId=98350.When I dowload the update in double click to launch installation I get the following message The upgrade pacth cannot be installed by the installer because the program to be upgraded may be missing or the upgrade patch may update a different version of the program. Verify that a program to be upgraded exist on your computer and that you have the correct upgrade patcch I also get message ID of 1536 signifying that the management point is not workinh Thanks Emma

See, http://social.technet.microsoft.com/Forums/sk/configmgrsetup/thread/82932f8b-8dc7-4d18-a001-38db82410997Anoop C Nair - @anoopmannur :: MY Site: www.AnoopCNair.com :: FaceBook: ConfigMgr(SCCM) Page :: Linkedin: Linkedin<

See, http://social.technet.microsoft.com/Forums/sk/configmgrsetup/thread/82932f8b-8dc7-4d18-a001-38db82410997Anoop C Nair - @anoopmannur :: MY Site: www.AnoopCNair.com :: FaceBook: ConfigMgr(SCCM) Page :: Linkedin: Linkedin<

I have setup SCCM on win28K server but when I run the pre-requisit checker, it give me the following result. This software update addresses a browse dialog box error that might occur when the Configuration Manager console is installed on computers with 64-bit microprocessors. This update should be applied only to computers experiencing this particular issue. More information about this update is available at: http://go.microsoft.com/fwlink/?LinkId=98350.When I dowload the update in double click to launch installation I get the following message The upgrade pacth cannot be installed by the installer because the program to be upgraded may be missing or the upgrade patch may update a different version of the program. Verify that a program to be upgraded exist on your computer and that you have the correct upgrade patcch I also get message ID of 1536 signifying that the management point is not workinh Thanks Emma have you downloaded the correct version of architecture for the patch, 64bit and not 32bit?

I have setup SCCM on win28K server but when I run the pre-requisit checker, it give me the following result. This software update addresses a browse dialog box error that might occur when the Configuration Manager console is installed on computers with 64-bit microprocessors. This update should be applied only to computers experiencing this particular issue. More information about this update is available at: http://go.microsoft.com/fwlink/?LinkId=98350.When I dowload the update in double click to launch installation I get the following message The upgrade pacth cannot be installed by the installer because the program to be upgraded may be missing or the upgrade patch may update a different version of the program. Verify that a program to be upgraded exist on your computer and that you have the correct upgrade patcch I also get message ID of 1536 signifying that the management point is not workinh Thanks Emma have you downloaded the correct version of architecture for the patch, 64bit and not 32bit?