Prompting For OU During OSD Task Sequence / Frontends
Good Morning!
Since I believe to have my OSD TS's set up the way I want them, I'm looking to add a couple of features. I've been looking at Niall's HTA
here as well as a few others like
this that may provide prompts for OU.
As far as Niall's I'm about done with the prerequisites, but don't see a place in his screenshots to prompt for an OU. Due to these OSD TS's being used by so many departments in my company, it's a must have.
Therefore, I found the other one (link above) which says it will prompt for an OU after easy setup. I followed the instructions except for the end where I was a little lost. I know how to mount and edit an image, but which boot.wim file do I
do it to and do I do this before or after I create the Boot Image package? I looked in one of my MDT boot image packages and it only had one WIM file - it wasn't boot.wim, though.
What do you think? Thanks!
Ben K.
July 11th, 2011 4:18pm