Hi, I have a master report with 2 subreports that each produce one page. The master report has a big tablix with a rectangle, and in that rectangle there are 2 talix which contain the subreports (this is necessary due to the way each page renders). On the big tablix there is a group on the Employee. This group has a page break (between) and ResetPageNumber = true. The rectangle has KeepTogether = true. The first subreport that produces page 1 has no page breaks etc. The second subreport has a page break (start). Now this works beautifully when you run the report from the web, export to Word or web archive etc. This seems like the accepted way to set up page numbering with subreports. Here's the numbering: Emp 1 page 1 of 2 page 2 of 2 Emp 2 page 1 of 2 page 2 of 2 Emp 3 page 1 of 2 page 2 of 2 etc . . . The problem is when I export to PDF. Here's what the numbering comes out like: Emp 1 page 1 of 1 page 1 of 1 Emp 2 page 1 of 1 page 1 of 1 Emp 3 page 1 of 2 page 2 of 2 Note: The last employee (in this case #3) always has the correct numbering and the rest always have 1 of 1. It doesn't matter if I selected 1000 employees. Now I've tried nearly every single combination of properites on the tablix, rectangle, group etc to no avail. Any ideas?