Hi,When adding /config:config.xml to the OSDMigrateAdditionalCaptureOptions TS Variable the TS fails because the config.xml file cannot be found. Is there a TS variable that points to the USMT Package Fles on the DP that can be used together with the OSDMigrateAdditionalCaptureOptions variable? When using standard settings for the Capture State the path to the MigUser.xml and MigApp.xpl configuration files is correctly resolved. Any help would be geratly appreciated. Thanks.

try creating the following Step in the State Capture part of your task sequence Set Task Sequence Variable OSDMigrateConfigFiles and fill in the following: Task Sequence Variable: OSDMigrateConfigFiles Value:Config.xml does that help ? OSDMigrateAdditionalCaptureOptions could be used as follows: Task Sequence Variable: OSDMigrateAdditionalCaptureOptions Value: /ue:*\* /ui:contoso\* /uel:90 cheers niall my SCCM step by step Guides > http://www.windows-noob.com/forums/index.php?showtopic=1064

Unfortunately this will add the Confog.xml file with the /i switch. As you probably know the file has to be used with the /config switch. any more ideas? Thanks.

You have to use the full path as such, C:\_SMSTaskSequence\USMT\config.xml

OSDMigrateAdditionalCaptureOptions= /config:"C:\_SMSTaskSequence\Packages\CAM0000A\x86\config.xml" where CAM0000A is my usmt package.But if you have more than one hard disk sccm might dump the usmt folder on the second drive therefore:/config:"D:\_SMSTaskSequence\Packages\CAM0000A\x86\config.xml"

Is there any way to use a variable instead of a hard path? Just like you mentioned, if you have more than one drive it will end up on a different system. Is there a variable the equates to C:\_SMSTaskSequence Thank you!