Im creating a new TS from the 2012 console, but when i tried to import the boot.wim, I encounter below error...

What does it mean by only finalized boot images are supported?

Hi,

It sounds like a problem with antivirus(mcafee blocking dism) perhaps? http://scug.be/sccm/2013/01/14/cm2012-sp1-no-default-boot-images-available-only-finalized-boot-images-are-supported/

Regards,
Jrgen

I even have uninstalled mcafee, but I still receiving the same error... Im not sure whether I am doing it correctly in importing the boot image, but it is just right click -> Add boot image correct? Then only i can create the TS correct?

I even have uninstalled mcafee, but I still receiving the same error... Im not sure whether I am doing it correctly in importing the boot image, but it is just right click -> Add boot image correct? Then only i can create the TS correct?

BTW, i am using SCCM 2012 SP1... I should be able to import it using SP1 correct?

• Edited by Efa77 Tuesday, October 29, 2013 6:47 AM

Search the net and read on the doc, it says SCCM 2012 SP1 cannot add the boot image into the console.... Is this correct to assume that, in order for me to able to add boot images into the console, I will only have to upgrade to CU1 onwards? Is there a workaround?

Anyone can help?

Not sure what the question is? The table above is for adding boot images based on different versions of WinPE. You can always add boot images of the same version directly supported by that version of ConfigMgr (this is generally preferred also).

CU1 does not change anything either.