Hello,

Looks like netsh command has changed in Windows 10, because the standard HE.NET solution for creating an ipv6 tunnel does not work anymore:

netsh interface teredo set state disabled
netsh interface ipv6 add v6v4tunnel interface=IP6Tunnel <ext-ip> 184.105.253.14
netsh interface ipv6 add address IP6Tunnel 2001:470:1f10:111f::2
netsh interface ipv6 add route ::/0 IP6Tunnel 2001:470:1f10:111f::1

( <ext-ip> = ip address I got from my ISP )

I get this result:

C:\>netsh interface teredo set state disabled
Ok.

C:\>netsh interface ipv6 add v6v4tunnel interface=IP6Tunnel <ext-ip> 184.105.253.14
The function attempted to use a name that is reserved for use by another transaction.
(I've used other names for the string IP6Tunnel - some in quotes - but with exactly the same result.)

C:\>netsh interface ipv6 add address IP6Tunnel 2001:470:1f10:111f::2
The filename, directory name, or volume label syntax is incorrect.
(Which baffles me since this is the suggested syntax for this command AND works in OLDER versions of Windows)

C:\>netsh interface ipv6 add route ::/0 IP6Tunnel 2001:470:1f10:111f::1
The filename, directory name, or volume label syntax is incorrect.
(Ditto here.)

On Windows 8.x and older it works like a charm, on Windows 10 IT IS BROKEN !!!
ALL commands are executed at an administrative command prompt !!!

Please help ... ?

Regards,
Jacob Havinga

Hi,

The netsh command is still available on Windows 10 as below:

You should contact Hurricane Electric broker to confirm if it's compatible with Windows 10.

This reference is for you to check your syntax:

http://www.putdispenserhere.com/ipv6-tunnel-setup-guide/

Please Note: Since the website is not hosted by Microsoft, the link may change without notice. Microsoft does not guarantee the accuracy of this information.