I add another couple of Devices with Direct Rule , both devices are Member visible in site and receiving other deployments fine.  --- check if the devices are appearing in the collection first.

Why if i go to monitoring - Deployments- and look for that deployment, they never appear -  They might not have received the deployment, you need to check the client agent status, check if its active and get in to control panel > configuration manager client > actions tab and check if all the cycles are present.

Hi Torsten.

Those clients are showed as Active,  and are receiving other deployments fine.  I add several other devices to the collection to receive this deployment,  in the collection i see them Added, but if i monitor the deployment as usually do, i cannot see them in the Completition statistics, like success, in progress, error, requirements not met. Its only 1 added the very first that works,  the following 4 are not bein showed.

They are in the collection, and they are active clients receiving other deployments.  But i just add them to this particular deployment, and one i did before, and they are not there.

I add several other devices to the collection to receive this deployment,  in the collection i see them Added, but if i monitor the deployment as usually do, i cannot see them in the Completition statistics, like success, in progress, error, requirements not met. Its only 1 added the very first that works,  the following 4 are not bein showed.

I just remove the application,  set it up again. Setup the collection again, setup the collection again.
I add 4 computers to the collection,  computers added fine, all of them active clients.

In the monitorin-deployment,  do not show non of them now   :'(

This is the firs time this happen to me.

I just setup an Application for Itunes , its being runned from a batch file, test in my Data Center where the Primary Site is to a Virtual Client Machine , everything worked fine.

I add another couple of Devices with Direct Rule , both devices are Member visible in site and receiving other deployments fine.

Why if i go to monitoring - Deployments- and look for that deployment, they never appear even if i run summarization or refresh, they just never are showed like , the only one added its the first one i test.

Download ConfigMgr Toolkit and use Deployment Monitoring Tool to check if the client received policies at all. And does the client show as active in the console? What about the latest timestamps (policy, inventory etc)?

Just a way of closure.  Apparently deployments as available (instead of required) do not added to deployment list, till they install it fron the software center.  It sounds so obvious now, but it didn't at the moment hahaha.  Thank you very much.