Broken lines in line chart 2008 R2 (revisited?)
After converting to RS 2008 R2 from 2005 I discovered the "phenomenon" of broken lines in my line chart.
Reading up on the subject there is one solution presented, namely to add the same color to the EmptyPoints as in the Chart Series.
And yes I does fill in the gaps, but it does it a little bit to “well”.
Se the “lines” below. The new unwanted behavior is that it expands the line to
other points in other Chart Series,
instead of just draw lines between points in its own Chart Series.
-----------------------------
-----------------------------
It should look like this (as it used to do in RS 2005), se below.
------------
----------------------
Any ideas/solutions?
So far I haven’t found the solution to the above behavior.
December 19th, 2010 8:13am